Option
Description
Device Name:
Indicates
the name under which the instrument is identified in the installation
environment (Also, refer to Naming
Devices...). To control the instrument via the existing Control Panels, accept
the default name. If you do not accept the default name, you may
have to edit the PGM Files and re-link the corresponding control
of the control panel. (Also, refer to How
to: Controlling Devices from the Control Panel 
Linking
a Control to a Device in the User
Help section.)
Serial Communication:
Select the serial interface to be used for connecting the instrument (Port). This is not possible in Demo Mode.
In addition, the current interface parameters (baud rate, data bits, parity, stop bits, and handshake) are displayed
Inject Port
Indicates the response of the injection port.
Channel
ADC Port Name: Select the name of the ADC port in the selection box.
Unit: Enter the corresponding unit, if necessary.
Factor: Enter the factor for multiplying the measured results before they are displayed, for example, as Channel1.
Offset: If required, enter a value to determine the offset for the measured signal.
Note: