Option

Description

Device Name

Indicates the name under which the instrument is identified in the installation environment (default: Pump; also, see Naming Devices...). To control the instrument via the existing Control Panels, accept the default name. If you do not accept the default name, you may have to edit the PGM Files and re-link the corresponding controls of the control panel. (Also, refer to How to: Controlling Devices from the Control Panel  Linking a Control to a Device.)

Stack ID

Select the number (1...99) that uniquely identifies the pump. The stack ID number is part of the network IP address and must match the rotary switch settings at the rear panel of the instrument.

Notes:

• The full IP address is in the following format: 172.16.x.141, whereby 'x' corresponds to the stack ID which is set using the two rotary switches at the rear panel of the device.

• After changing the rotary switch settings, the pump must be powered OFF and ON again to allow the changes to take effect.

Virtual Mode

Select this check box to enable virtual mode.

Limits...

Click on this button to open the Limits configuration dialog.

Solvents...

Click on this button to open the Solvents configuration dialog.