Defining System Suitability Tests

Chromeleon offers a number of predefined System Suitability Test (SST). It also offers a Wizard to help you customize the predefined tests and to create new SST tests. In this section all the Wizard pages and system suitability test parameters (conditions) are explained.

 Tip:

In order to perform a System Suitability Test, enter the QNT File into the sample list before you start the analysis. If you start the analysis before the QNT File has been entered, the test is not performed during the batch run. Thus, the Batch cannot be aborted in case of Fail Action - Abort Batch.

To open the SST Wizard

1. Open the  QNT Editor.

2. Go to the SST tab.

3. Each test is defined on a separate line. To append additional lines to the table, select Insert Line from the context menu or press the down arrow key from the bottom line.

The SST Wizard will guide you through all additional steps.

For more information, refer to:

 SST Wizard: Selecting a Test Template

 SST Wizard: Sample and Test Conditions

 SST Wizard: Other Wizard Pages

 Modifying the System Suitability Test

 SST Example: Is the Amount in the Calibrated Range?

 SST Example: Amount Deviation on Reinjection

 Inserting SST Results in the Printer Layout