Tab Dialog Box:
General
Configure the general device and hardware parameters such as Demo Mode and port address of the A/D converter.
|
Option
|
Description
|
|
|
|
|
Port Address:
|
The Hex and Decimal fields indicate the current interface address as hexadecimal or decimal number. Modify the decimal value to change the address. The hexadecimal value will be calculated automatically.
For more information, refer to Hardware Installation  Installing the A/D Converter/Setting the Base Address.
|
|
|
|
|
Demo Mode:
|
Select Off to disable the demo mode.
Select Write to save the data currently delivered by the detector in a demo file. Data is recorded only for those channels that were selected in the list. Enter the (directory and) file name in the Demo File Name input field.
Select Read to read and display data from an existing demo file instead of real data. Select a demo file from the Demo File Name drop-down list.
|
Tip:
The available relays and remote inputs available on the card are Sharable Devices. Thus, they can be used independently from timebases. To use them with a specific timebase, an additional driver must be installed for each timebase that uses one or more of those relays and/or remote inputs. Select Add Device on the Edit or context menu. In the Add device to timebase dialog box, select General from the Manufacturers list box, and then select Shared Relays and Inputs. Click Add to add the required relays and/or remote inputs.
For analog signals, install the respective Device Driver by selecting the manufacturer's name from the left list box and the device name from the right list box. Or else, install the Integrator Driver in the same way as the Shared Relays and Inputs driver, and then select the signals.