Finnigan/TSP UV1000 DetectorCommands and Tips for Thermo Scientific Devices
Finnigan/TSP UV1000 Detector
The following commands and properties are available (please note that the display Filter level determines which commands and properties are displayed):
|
Property |
Min |
Max |
Default |
Description |
|
AvailableLamps |
None |
UV & VIS lamps |
UV lamp only |
Indicates which lamps are available. |
|
Range |
0.0005, 0.001, 0.002, 0.005, 0.01, 0.02, 0.05, 0.1, 0.2, 0.5, 1.0, 2.0, 3.0 |
1.0000 |
Amplifying factor in [AUFS] for the output signal. |
|
|
Response |
0.0 |
5.0 |
1.0 |
Time constant. Indicates the time needed by the detector to reach 63% of the full-scale deflection. |
|
Wavelength |
190 nm |
800 nm |
UV lamp: 254 nm VIS lamp: 430 nm Both lamps: 254 nm |
Wavelength at which the detector measures the signal: UV lamp only: 190 - 380 nm VIS lamp only: 366 - 800 nm Both lamps: 190 - 800 nm, 190 - 380 nm (UV lamp on) 381 - 800 nm (VIS lamp on) |
|
ZeroOnLambda |
Off |
On |
Off |
Determines whether the detector performs an Autozero every time the wavelength is changed. |
|
Command |
Description |
|
UV_LampOn |
Turns the deuterium lamp on. |
|
UV_LampOff |
Turns the deuterium lam off. |
|
Visible_LampOn |
Turns the tungsten lamp on. |
|
Visible_LampOff |
Turns the tungsten lamp off. |
Tip:
After a Reset command, it takes 90 seconds until the detector is ready to execute further commands.