Perkin Elmer Series 200 Pump: Commands and Tips

Commands and Tips for Third-Party Devices
Perkin Elmer Series 200 Pump

Chromeleon provides the commands and parameters from the table below (please note that the display Filter level determines which commands and properties are displayed) to control the Perkin Elmer Series 200 Pump. Also, refer to the information in the pump's Operating Instructions.

General Commands and Properties

Command/Property	Description
Connect	Connects the device to Chromeleon
Connected	Indicates whether the instrument is connected to Chromeleon, that is, under computer control (also, see Connect, Disconnect)
Disconnect	Disconnects the instrument from Chromeleon and activates manual control from the instrument panel.
DriverID	Unambiguous driver name (read-only).
DriverVersion	Driver version (read-only).
Firmware	Firmware version (read-only).
ModelNo	Model number (read-only).
Manufacturer	Manufacturer of the driver (read-only).
Ready	Set to "Ready" when the pump is ready for operation. Values: Ready and NotReady (read-only).
SerialNo	Serial number of the pump (read-only).

Special Commands:

Command/Property	Description
Flow	Sets the flow rate [ml/min].
*.Nominal	Reports the nominal flow.
*.Value	Reports the current flow.
%A, %B, %C, %D	Percentage of each solvent component.
*.Value	Current value [%] for components A, B, C, or D
*.Equate	Name of the component (A, B, C, or D)
Pressure	Reports the pressure [bar] (read-only).
*.Value	Current pressure
*.LowerLimit	Lower Pressure Limit
*.UpperLimit	Upper Pressure Limit

Further Information

For an installation overview, refer to Installing and Controlling Third Party Devices Perkin Elmer Series 200 Pump: Installation in the Administrator Help section.