Agilent 1100/1200 HPLC System: GeneralCommands and Tips for Third-Party Devices
Agilent 1100/1200 HPLC System: General
The following commands and properties are available (please note that the display Filter level determines which commands and properties are displayed):
|
Property |
Description |
|
Firmware |
Indicates the firmware version of the module (read-only) |
|
ModelNo |
Reports the module number (read-only) |
|
ModuleType |
Reports the module type, e.g., G1315A for the DAD detector (read-only) |
|
NotReadyCauses |
String to explain why the module is not yet ready for the next analysis (read-only) |
|
SerialNo |
Indicates the serial number of the module (read-only) |
|
Command |
Description |
|
Connects the device. |
|
|
Disconnect |
Disconnects the device. |
|
Identify |
Identifies the module (the module LED will flash). |
|
Resets the device to the default values. |
|
Name |
Possible States |
Description |
|
AnalysisState |
NoAnalysis, |
Retention time state |
|
AnalysisTime |
0 outside of analysis, analysis time in minutes since analysis start. |
Retention time |
|
ErrorState |
NoError |
Error state |
|
ReadyState |
NotReady |
Ready state |
|
RuntimeState |
Prerun |
Run time state |
|
RunTime |
0 outside of run, runtime in minutes since run start. |
Run time |
|
TestState |
NoTest |
Test state |
The Administrator Help section provides installation instructions for the 1100 and 1200 HPLC systems; refer to Hardware Installation:
Agilent 1100 HPLC System: Installation
Agilent 1200 HPLC System: Installation