Command/Property

Range/Values

Description

ControlMode

Dual, SingleLeft, SingleRight

Sets the control mode. When the control mode is set to “Dual,” flow controllers on both left and right inlets are controlled. When it is set to “SingleLeft” or “SingleRight,” a flow controller on either left or right inlet is controlled.

LeftColLength/ RightColLength

0.1 m to 250.0 m

Indicates the left/right column length.

LeftFilmThickness/ RightFilmThickness

0.0 µm to 300.0 µm

Indicates the  left/right film thickness of the column.

LeftFlow/ RightFlow

Indicates the  left/right carrier gas flow properties [ml/min].

*.Nominal

0 to 1200 ml/min

Sets the nominal flow for the carrier gas at the output of the capillary column.

*.Value

Indicates the current carrier gas flow measured at the output of the capillary column.

LeftGasType/ RightGasType

He, N2, H2, Ar

Indicates the type of carrier gas.

LeftInnerDia/ RightInnerDia

0.01 mm to 6.00 mm

Indicates the internal diameter of the left/right column (read-only).

LeftPressure/ RightPressure

Indicates the properties of the inlet's left/right column pressure [kPa].

*.Nominal

0.0 to 979.0 kPa

Sets the nominal pressure of the column (read-only).

*.Value

Indicates the current pressure in the column head.

Temperature

Sets the temperature properties [°C].

*.Value

0°C to 400°C

Sets the current inlet temperature (read-only).

*.Nominal

0°C to 400°C

Sets the target operating temperature for the inlet.

*.UpperLimit

10°C to 400°C

Sets the maximum inlet operating temperature.

Type

Unknown
DINJ-2014

Indicates the selected inlet type (read-only).