Perkin Elmer Series 200 Column OvenCommands and Tips for Third-Party Devices
Perkin Elmer Series 200 Column Oven
Chromeleon provides the commands and parameters from the table below (please note that the display Filter level determines which commands and properties are displayed) to control the Series 200 Column Oven. Also, refer to the information in the column oven's User's Manual.
General Commands and Properties
|
Command/Property |
Description |
|
Connect |
Connects the device to Chromeleon |
|
Connected |
Indicates whether the instrument is connected to Chromeleon, that is, under computer control (also, see Connect, Disconnect) |
|
Disconnect |
Disconnects the instrument from Chromeleon and activates manual control from the instrument panel. |
|
DriverID |
Unambiguous driver name (read-only). |
|
DriverVersion |
Driver version (read-only). |
|
ModelNo |
Reports the instrument's model number (read-only). |
|
Manufacturer |
Manufacturer of the driver (read-only). |
Column Oven Commands:
|
Command/Property |
Range/Value |
Description |
|
EquilibrationTime |
0 - 60 min |
The column oven enters the Ready state only if the deviation between the current temperature and the set point temperature did not exceed the maximum deviation specified under ReadyTempDelta for the time specified here (see also ReadyTempDelta and Ready). |
|
Ready |
Ready, NotReady |
Indicates whether the instrument is ready for injection (read-only). |
|
ReadyTempDelta |
0.1° C - 5.0° C |
The instrument enters the NotReady state, if the current temperature deviates from the temperature set point by more than the ReadyTempDelta. If the ReadyTempDelta is set to None, Chromeleon does not check whether the temperature set point deviates from the actual temperature (see also EquilibrationTime) |
|
Temperature.Nominal |
5.0° C - 90° C |
Temperature setpoint for the column oven. |
|
Temperature.Value |
0.0° C - 120° C |
Current temperature of the column oven. |