Tab Dialog Box:
Inject Port (Gilson 215)

There are two Inject Port tab pages because two inject ports can be used. If you are using both ports, you are required to make the corresponding settings on both tab pages.

 

Installed:

Select this check box.

 

 

Name:

Enter a name for the port.

 

 

GSIOC Address:

Enter the GSIOC address.

 

 

Loop Volume:

Enter the loop volume in [µl]. Make sure that your input is correct; otherwise, any volume calculations will be incorrect.

X, Y, Z:

Enter the home coordinates of the injection needle. Make sure that your input is correct, otherwise the injector cannot move to the correct inject position.

 

For information about how to install the autosampler, refer to Hardware Installation  Gilson 215 Liquid Handler.