Temperature Signal

This check box is selected by default. Accept this setting if you want to record the temperature as a separate channel. Dionex recommends that you accept the default name under which the temperature signal is identified in the installation environment (ColumnOven_TEMP for the TCC-3x00(RS/SD); TC_Temp for the ICS-3000 TC or ICS-5000 TC). If you do not accept the default name, you have to re-link the corresponding controls of the control panel.

Cooler Temp. Signal

(TCC-3000RS/SD only) This check box is selected by default. Accept this setting if you want to record the temperature of the post-column cooler as a separate channel. Dionex recommends that you accept the default name under which the temperature signal is identified in the installation environment (Post_Column_Cooler_Temp). If you do not accept the default name, you have to re-link the corresponding controls of the related control panel.

Note: The signal will be recorded only if you have selected the post-column cooler check box on the Components page.

Pressure Unit

Select the unit of measurement (bar, psi, or MPa) for pressure values saved on the column ID chip card.

For details about the types of information that can be saved on chip cards, refer to  Dionex TC/TCC-100/TCC-3x00(RS/SD) Thermostatted Column Compartments: Column ID Properties.

Rear Temperature

The check box is selected by default. Accept the default setting if you want to record the signal as a separate channel. If a problem occurs, the channel can provide helpful information to identify and eliminate the source of the problem.

TCC-3x00: The check box must be selected if you want to run the Thermo Unit Test for the TCC-3x00.