Diagnostics (UltiMate 3000 Series)
Drives and Sensor Test

Run this test to check the WPS-3000SL/RS/TXRS motors, sensors and injection valve.

Required materials and preparatory measures

No materials required.

How to

1. On the first test page, click Next> to proceed with the settings required for the test.

    Tip: 

   If the Next> button is not active on the first test page, the autosampler is not connected in Chromeleon or in Standby mode. Connect the autosampler to Chromeleon before you continue by selecting the Connected check box. If the autosampler is in Standby mode, you must also clear the Standby check box. Depending on the speed settings, the autosampler may take up to two minutes to run a self test and awake from Standby mode. If the self test fails, perform the Drives and Sensor Test, anyway, to get a more detailed analysis of the hardware problem that may have occurred.

2. Optional: Enter a descriptive text in the Comments field, e.g., the reason why the test is performed.

3. Clicking Next> takes you to the next test step(s). Follow the instructions on the panel(s).

4. To view or print the report with details of the analysis, click Finish and Preview Report. Click Finish to quit the test panel without viewing the report. For information about troubleshooting, click Open Troubleshooting Guide.

For general information, refer to  Diagnostics (UltiMate 3000 Series).

For more diagnostic tests, refer to:

 Leak Test

 General Leak Test (UltiMate 3000 Pumps)