Installing the Pump Control Card
Selecting the I/O Address on the Pump Control Card

 Tips:  

Due to its obsolete technology, the pump control card is no longer available from Dionex. However, pump control cards may still be used in the field. Therefore, refer to the installation instructions below if necessary.

This card is not supported under Windows Vista or later.

The JP1 pin field on the pump control card contains four pins. Set the jumpers to configure the I/O address of the pump control card.

The pump control card requires 13 consecutive I/O addresses. 350H is the default address. For information about the I/0 addresses for the jumpers, refer to the picture below: